Current position: Home > Products > Index M > MBM29PL160BD-75
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 All

MBM29PL160BD-75

Vendor: N/A
Package Cooled: SOP
D/C: 06+

Description

TRI-STATE is a registered trademark of National Semiconductor Corporation SuperI OTM is a trademark of National Semiconductor Corporation IBM MicroChannel PC-AT and PS 2 are registered trademarks of International Business Machines Corporation

Applications

RESET: An active high signal on this pin will put the chip into an inactive state. All Control Register bits (CR0, CR1, tone) will be reset. The output of the CLK pin will be set to the crystal frequency. An internal pull-down resistor permits power-on-reset using a capacitor to VDD.

Features

The IC must be equipped with external RC circuitry to limit the voltage in the event of power surges (see Figure 3 on page 3). This prevents the circuit from being damaged or destroyed, and provides a buffer in case of power fluctuations at VBatt. The RxD compar- ator is powered via pin VS, producing its reference voltage of 1/2 V S, while all other blocks are supplied via VCC.

Supplier

  • Part Name
  • Q'ty
  • Description
  • Vendor
  • Date Code
  • Date
  • Quotation
  • MBM29PL160BD-75
  • 3650
  • special supplier for wirless digital communication goods
  • N/A
  • SOP
  • 2017-10-17

Send your message to supplier

Related Parts No.

· MBM0474A-7

D/C:N/A   

· MBM100422A7

Vendor:fujitsu   Package Cooled:fujitsu   D/C:dc88   

Description: The wide operating supply range and high accuracy make the LTC6101 ideal for a large array of applications from automotive to industrial and power management. A maxi- mum input sense voltage of 5...

Applications: The Intersil ICL32XX devices are 3.0V to 5.5V powered RS-232 transmitters/receivers which meet ElA/TIA-232 and V.28/V.24 specifications, even at VCC = 3.0V. Targeted applications are PDAs, Pa...

Features: The nominal value of the RF choke, L1 is 100 nH. At frequencies below 100 MHz this value should be increased to 200 nH. At frequencies between 1 and 3 GHz a much lower value must be used (e.g. 1...

· MBM100422A-7

Vendor:FUJ   D/C:90   

Description: Test Condition Vss < VIN < Vcc Vss < VOUT < Vcc, /CS1 = VIH or CS2=VIL or /OE = VIH or /WE = VIL or /UB = VIH , /LB = VIH /CS1 = VIL, CS2=VIH, VIN = VIH or VIL, II/O = 0mA /CS1...

Applications: The UC1842A/3A/4A/5A family of control ICs is a pin for pin compati- ble improved version of the UC3842/3/4/5 family. Providing the nec- essary features to control current mode switched mode po...

Features: The MBM100422A-7, MBM100422A-7, MBM100422A-7, MBM100422A-7, MBM100422A-7, MBM100422A-7 family of adjustable frequency, low power, pulse width modulating (PWM) current mode controllers is designed...

· MBM100470A-10

Vendor:F   Package Cooled:88+   D/C:DIP18   

· MBM100470A15

Description: between X2 and ground. Stuffing of these capacitors on the PCB is optional. The need for these capacitors is determined at system prototype evaluation, and is influenced by the particular cry...

Applications: As a result of the high precision and low-noise characteristics of the OPA380, a dynamic range of 5 decades can be achieved. This capability allows the measurement of signal currents in the o...

Features: The MBM100470A15 is a CCD signal processor for digital cameras. The processor provides a common interface to a number of different image sensors including CCD, CMOS, and CIS. Correlated double sa...

· MBM100474A-10

Vendor:FUJ   Package Cooled:.   

Description: The 3.3V device is fully accessible and data can be written or read only when VCC is greater than VPF. When VCC falls below the power-fail point, VPF , access to the device is inhibited. If VPF is...

Applications: S0 Pin The S0 pin is used to select the mode of operation as shown in Table 1. The S0 pin contains an internal Schmitt trigger as part of its input to improve noise immunity. The S0 pin has ...

Features: The MBM100474A-10 is the 12-bit resolution member of the TxDAC series of high performance, low power CMOS digital-to-analog converters (DACs). The TxDAC family which consists of pin compatible...

· MBM100474A-10(MBM100474A-15)

Vendor:F   Package Cooled:DIP-24   D/C:03+   

· MBM100474A-15

Vendor:FUJ   Package Cooled:CDIP   

Description: This document is a general product description and is subject to change without notice. Hyundai Electronics does not assume any responsibility for use of circuits described. No patent licenses are...

Applications: The MBM100474A-15 series of NPN epitaxial silicon transistors are designed for low voltage/low current, amplifier and oscillator applications. MBM100474A-15's high fT make it an excellent choic...

Features: The MBM100474A-15CMBM100474A-154 are serial-input, voltage-out- put, 16-bit digital-to-analog converters (DACs) in tiny µMAX packages, 50% smaller than comparable DACs in 8-pin SOs. They op...

· MBM100474A-5

Vendor:FUJ   Package Cooled:.   

Description: Note: The remote sense feature is not designed to compensate for the forward drop of non-linear or frequency dependent components that may be placed in series with the converter output. Exampl...

Applications: CAUTION ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on the human body and test equipment and can discharge without detection. Altho...

Features: Operation of the devices described herein with conditions above those listed under Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation ...

· MBM100480-15

Vendor:FUJITSU   Package Cooled:DIP   D/C:1985   

Description: When #CE and #RESET pins are at VDD, the ICC CMOS standby mode is enabled. When the #RESET pin is at VSS, deep power-down mode is enabled which minimizes power consumption and provides write pro...

Applications: The 74LVC1GX04 combines the functions of the 74LVC1GU04 and 74LVC1G04 into a single package to provide a device optimized for use in crystal oscillator applications. This integration produces t...

Features: The MBM100480-15 signal processor is a FLEXt signal processor that takes full advantage of the MotorolaR FLEX paging protocol. This low-current device operates at synchronous data rates of 1600,...

Hot Part Number

Home About Us Map Online Inquiry
© 2009-2011 ExchangeIC.com Corp.All Rights Reserved