Current position: Home > Products > Index M > MN3611RE
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 All

MN3611RE

Vendor: PANASONIC
Package Cooled: DIP
D/C: 96+

Description

The flag bit is a volatile bit. It can be used to determine if a reset condition was due to a power failure or watchdog reset condition. If power fails (i.e. the internal low voltage detect signal goes active), the bit is set to 0. This bit is also set or reset by a Control Register write operation. A watchdog reset does not change the state of the flag bit.

Applications

The A-to-B enable (CEAB) input must be low in order to enter data from A or to output data from B. If CEAB is low and LEAB is low, the A-to-B latches are transparent; a subsequent low-to-high transition of LEAB puts the A latches in the storage mode. With CEAB and OEAB both low, the 3-state B outputs are active and reflect the data present at the output of the A latches. Data flow from B to A is similar but requires using the CEBA, LEBA, and OEBA inputs.

Features

Port 1 C I/O. Port 1 functions as both an 8Cbit biCdirectional I/O port and an alternate functional interface for Timer 2 I/O, new External Interrupts, and new Serial Port 1. The reset condition of Port 1 is with all bits at a logic 1. In this state, a weak pullCup holds the port high. This condition also serves as an input mode, since any external circuit that writes to the port will overcome the weak pullCup. When software writes a 0 to any port pin, the MN3611RE will activate a strong pullCdown that remains on until either a 1 is written or a reset occurs. Writing a 1 after the port has been at 0 will cause a strong transition driver to turn on, followed by a weaker sustaining pullCup. Once the momentary strong driver turns off, the port again becomes the output high (and input) state. The alternate modes of Port 1 are outlined as follows.

Supplier

  • Part Name
  • Q'ty
  • Description
  • Vendor
  • Date Code
  • Date
  • Quotation
  • MN3611RE
  • 17
  • PANASONIC
  • DIP镜
  • 2017-10-17
  • MN3611RE
  • 3200
  • CCD图像传感器
  • 2017-10-17
  • MN3611RE
  • 350
  • call me any time
  • PANASONI
  • 2017-10-17
  • MN3611RE
  • 3210
  • NEED LEAD TIME
  • PANASONI..
  • CDIP
  • 2017-10-17
  • MN3611RE
  • 60000
  • ECRAI@MSN.COM
  • PANASONIC
  • 2017-10-17
  • MN3611RE
  • 200
  • 现货库存 欢迎查询
  • Panasonic
  • DIP扫描镜
  • 2017-10-17
  • MN3611RE
  • 3200
  • 现货库存
  • PANASONI..
  • CDIP
  • 2017-10-17
  • MN3611RE
  • 17
  • In stock
  • PANASONIC
  • DIP
  • 2017-10-17
  • MN3611RE
  • 42654
  • PANASONIC
  • DIP
  • 2017-10-17
  • MN3611RE
  • 1000
  • stock in hand
  • Panasonic
  • DIP
  • 2017-10-17
  • MN3611RE
  • 5800
  • PAN
  • 镜面DIP-22
  • 2017-10-17
  • MN3611RE
  • 17
  • PANASONIC
  • DIP镜
  • 2017-10-17
  • MN3611RE
  • 1
  • 现货库存 拆板旧
  • Panasonic
  • 2017-10-17
  • MN3611RE
  • 3
  • 绝对现货
  • PAN
  • DIP
  • 2017-10-17
  • MN3611RE
  • 138000
  • New and original
  • 2017-10-17
  • MN3611RE
  • DIP
  • Panasonit
  • 3215
  • 2017-10-17
  • MN3611RE
  • DIP
  • Panasonic
  • 3920
  • 2017-10-17
  • MN30005
  • 120
  • new & original package and in our stock
  • 2017-10-17
  • MN3001
  • 125
  • call me any time
  • MIT
  • .
  • 2017-10-17
  • MN3001
  • 60000
  • ECRAI@MSN.COM
  • PANASONIC
  • 2017-10-17
  • MN3001
  • DIP14
  • 现货库存欢迎订购
  • Panasoni
  • NULL
  • 2017-10-17
  • MN3001
  • 10
  • Matsushita
  • IC DIP14
  • 2017-10-17
  • MN3002
  • 1760
  • original
  • DIP
  • 2017-10-17

Send your message to supplier

Related Parts No.

· MN30005

D/C:07/08+   

· MN3001

Vendor:Matsushita   Package Cooled:.   

Description: NOTE 4: Apply a −1 dBFS 10-KHz triangle wave at AIN+ and AIN− with an internal bandgap reference and ADC reference enabled, and BIASREF enabled at AVDD/2. Any additional load at BIA...

Applications: Hold: Indicates that another master is requesting the use of the address and data buses. The CPU, upon receiving the hold request, will relinquish the use of the bus as soon as the completion o...

Features: † Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or an...

· MN3001438

· MN3002

Package Cooled:DIP   D/C:hot sell   

Description: A family of products offers 3-line, 2-line, and simple decod- ers in 8-bit and 10-bit versionsall in a pin and software- compatible format. Serial and parallel control ports are pro- vided. Th...

Applications: n PSRR at 217 Hz and 1kHz65dB (typ) n Output Power at 1kHz with VDD = 2.4V, 1% THD+N into a 16Ω load25mW (typ) n Output Power at 1kHz with VDD = 3V, 1% THD+N into a 16Ω load40mW...

Features: As with all Maxim devices, ESD-protection structures are incorporated on all pins to protect against electro- static discharges (ESD) encountered during handling and assembly. The MN3002E driver ...

· MN300270

· MN3003

Vendor:PANASONIC   

Description: The THAT 1510 and 1512 are high perfor- mance audio preamplifiers suitable for micro- phone preamp and bus summing applications. The ICs are pin compatible with the Analog De- vices SSM2017...

Applications: Extremely Wide Operating Voltage 1.5 to 3.6 Volts Extended Temperature Range Standard: -20 o to +80oC Fast Cycle Time Standard: < 70 ns @ 3 Volts -10: < 100 ns @ 3 Volts Very Lo...

Features: The serial 8-bit row address SAR and the 8-bit column address/mode code SAC are serially shifted into the TV-SAM (LSB first) at rising edge of the address clock SCAD. After 8 SCAD cycles, the ...

· MN3004

Vendor:AD   Package Cooled:N/A   

Description: A B C D (Pins 7 1 2 6) BCD data inputs A (pin 7) is the least-significant data bit and D (pin 6) is the most significant bit Hexadecimal data ACF at these inputs will cause the outputs to assum...

Applications: Single supply: 1.8 V to 5.5 V Two-wire serial interface (I2CTM serial bus* 1) Clock frequency: 400 kHz Power dissipation:  Standby: 3 µA(max)  Active (Read): 1 mA(max)...

Features: In the event that any or all SANYO products(including technical data,services) described or contained herein are controlled under any of applicable local export control laws and regulations, suc...

· MN3005

Vendor:Panasonic   Package Cooled:DIP   D/C:og stock   

Description: Page-mode operation allows faster memory access by keeping the same row address while selecting random column addresses. The time for row-address setup and hold and address multiplex is eliminat...

Applications: DESCRIPTION The LD1117A is a LOW DROP Voltage Regulator able to provide up to 1A of Output Current, available even in adjustable version (Vref=1.25V). Concerning fixed versions, are offered ...

Features: The Hynix MN3005 Series are Dual In-line Memory Modules suitable for easy interchange and addition of 256Mbytes memory. The Hynix MN3005 Series are fully synchronous operation referenced to the ...

· MN3005679

· MN3006

Vendor:MOT   Package Cooled:DIP   D/C:n/a   

Description: The TICPAL22V10Z has internal electrostatic discharge (ESD) protection circuits and has been classified with a 2000-V ESD rating tested under MIL-STD-883C, Method 3015.6. However, care should be...

Applications: The MN3006/MN3006s 2.7 V supply voltage, low supply current, serial interface, and small package size make it ideal for a variety of applications, including personal computers, office equipmen...

Features: International Rectifiers RADHard HEXFET® technol- ogy provides high performance power MOSFETs for space applications. This technology has over a de- cade of proven performance and reliabi...

Hot Part Number

Home About Us Map Online Inquiry
© 2009-2011 ExchangeIC.com Corp.All Rights Reserved